Devious 4 Report post Posted September 24, 2012 Hi Chaps, Im about to embark on a journey of descovery into Selespeed on a soon to be aquired 147 2.0 TS. According to my colleague (the current owner) there is a pipe from the reservoir to the pump (Ive never seen a selespeed box or its set up so i dont know) that needs replacing as its dropping pressure and causing odd skipping of the gears at low speeds/town driving but its fine on motorways etc. Is this likely to be the case? I own the "trial" version of MES (i drive a fiat so its essential stuff) will that be able to deal with the calibration etc? Many thanks in advance. Ta Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted September 25, 2012 That is not going to be the cause unless it's leaking enough to drain the reservoir. Quote Share this post Link to post Share on other sites
Devious 4 Report post Posted September 25, 2012 Ok. Thanks for the reply. Will the trial MES be able to sort out the calibration do you know? Thanks in advance. Ta Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted September 25, 2012 No it wont. Quote Share this post Link to post Share on other sites
Devious 4 Report post Posted September 25, 2012 Ok. I'll grab a copy of the licensed version. Thanks for your help. Ta Quote Share this post Link to post Share on other sites
