Jump to content

el@d147

Members
  • Content Count

    4
  • Donations

    0.00 GBP 
  • Joined

  • Last visited

Community Reputation

4 Neutral

1 Follower

About el@d147

  • Rank
    newbie

Converted

  • What car do you drive?
    147
  • Location
    israel
  1. Admin, please close this Topic. I opened it by mistake in the wrong place.
  2. I'll start with the fact that i replaced the brakes booster unit (include the pump). Before that everything was just fine! Now i have 2 problems: 1. In city mode the gears doesnt change, for example if i start from 1st gear the rpm goes up but the gear stay on 1st. Same problems with all gears if i go from any gear on manual to city, Gear stay on the last 1 before i changed to city mode from manual. 2. In manual mode gears changes are ok except selespeed fail beeps and the kangaroo jumps problem. I have really bad kangaroo jumps from standing state on 1st gear (low rpm) until i rev up and change to 2nd gear. it feels like there is not enough fuel in the system. my guess its a sensor problem but its not a real direction to the solution. Btw, road clutch set to 28.1mm. I tried to do EOL calibration but i have problem almost 3 years with it. It failed and say: "Error due to absence of suitable conditions" Thanks for any help here
  3. I'll start with the fact that i replaced the brakes booster unit (include the pump). Before that everything was just fine! Now i have 2 problems: 1. In city mode the gears doesnt change, for example if i start from 1st gear the rpm goes up but the gear stay on 1st. Same problems with all gears if i go from any gear on manual to city, Gear stay on the last 1 before i changed to city mode from manual. 2. In manual mode gears changes are ok except the kangaroo jump problem. I have really bad kangaroo jumps from standing state on 1st gear (low rpm) until i rev up and change to 2nd gear. it feels like there is not enough fuel in the system. my guess its a sensor problem but its not a real direction to the solution. Btw, road clutch set to 28.1mm. I tried to do EOL calibration but i have problem almost 3 years with it. It failed and say: "Error due to absence of suitable conditions" Thanks for any help here!
  4. Hi guys, I have this error and cant solve it , tried to clean contacts and replace on/off passenger airbag switch with used 2nd hand and after reset it was clean for 1 week and then the airbag light showed up again 1st the yellow light showing up and then the red is join her/ i wish someone can help me with this one, Elad. btw, cant upload the picture so i added this link ill be glad if someone can uplaod it correctly https://files.fm/u/4d3znp3c
×
×
  • Create New...