Cas 2 Report post Posted September 28, 2016 (edited) I have spent the day putting in a Selespeed box today , it's been reconditioned recently. I tested the selector plunger and it selected all the gears before i started to install it Had trouble getting the box in place, first time at it. *I find now as i try to install the actuator the plunger won't retract into the box and so i can't engage gears when i rotate the selector shaft by hand? Have i burred the selector plunger bore or have i bent something . Disappointing day! Tried rotating the gearbox internals , wheel to help, clutch put in release, propped to help but it won't budge. Help ? Edited September 28, 2016 by Cas Quote Share this post Link to post Share on other sites