alfizta 6 Report post Posted June 27, 2014 it's the bolt pointing left/upwars that I want to adjust to get a quicker response from the throttle valve. throttle cable is already tight as it can get. I only want to know if I am messing with something serious, or wont give me that much trouble... thank you! Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted June 27, 2014 DO NOT MESS WITH THE WAY THIS IS SET UP. The slack in the cable is to allow for choke and the screw is set at the factory and should NEVER be adjusted. Quote Share this post Link to post Share on other sites
alfizta 6 Report post Posted June 27, 2014 (edited) and if I just screw it in just before the throttle valve opens? Edited June 27, 2014 by alfizta Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted June 28, 2014 Just don't. If you think response is down then just remember that electronics are involved and that will cause a delay no matter what, CF3s are even slower and you can tell. Quote Share this post Link to post Share on other sites
alfizta 6 Report post Posted June 30, 2014 I confirm it. DON'T touch it! Quote Share this post Link to post Share on other sites
alfizta 6 Report post Posted June 30, 2014 I simulated the tuning by fitting bits of 0,5mm thick plastic between the bolt and the metal stop, and it was enough to change the idle speed. so, is better not to touch it. Quote Share this post Link to post Share on other sites
