alfaholic 001 0 Report post Posted July 18, 2011 Hi guys, my alarm button seems to have burnt out, iv got another red key from my smashed car, will it be ok to swap ONLY the button over??? Quote Share this post Link to post Share on other sites
alfaholic 001 0 Report post Posted July 19, 2011 Thanks Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted July 19, 2011 Be careful though as they can melt when your trying to remove them. Quote Share this post Link to post Share on other sites
alfaholic 001 0 Report post Posted August 15, 2011 Sorted out the problem guys, was the rubber from the casing that corroded and seized up the button so all I did was cleaned the button thoroughly with a bit of prepsol and replaced the rubber, now its all good Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted August 16, 2011 Corroding rubber? Quote Share this post Link to post Share on other sites
alfaholic 001 0 Report post Posted August 17, 2011 Yes, the part of the complete key that we press Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted September 5, 2011 Rubber Corroding.... I think you mean perishing , going sticky and jamming the switch. Quote Share this post Link to post Share on other sites
alfaholic 001 0 Report post Posted September 5, 2011 Yes that is correct Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted September 6, 2011 That is caused by the ingress of moisture (sweat) when the keys are in your pocket. Quote Share this post Link to post Share on other sites
alfaholic 001 0 Report post Posted September 6, 2011 I see Quote Share this post Link to post Share on other sites