Search the Community

Hi and hello from Sweden. I'm puzzled about my daugthers 147 Selespeed. Bougth it a couple of weeks ago and then it didn´t even start. From there I have manage to get it to start and also driven it shortly, with all gears in action. Now it is stuck in N, still the engine starts though. I think it has been filled with the wrong Sele-oil, red coulered I guess is Dextron, or at least not CS Speed. I have now drained and refilled it with CS and levelled. Pump is working, clutch rod is adjusted, no fault codes and all solenoids sounds and seem to be working when activated with FES. The 20-pin connector have been disconnected and connected 50 times or more. Also been over the relay. Battery seems ok. Calibration returnes "1st and 2nd sel. error". Readings from FES as per below engine off and on: Could anyone (Smaky I guess ) spot anything wrong. What would be likely to check next? Disconnect/connect stick and check micro-switches? Brake sensor, brake light is working... Any specific wiring/solenoids/connectors/relay/fuse. Any help will be much appriciated here in Sweden!