addicto111 0 Report post Posted October 26, 2015 Hi I got problems with selespeed with gears flashing, recently changed accumulator. clutch rod adjustment to 28.5 but it changes when i increases to higher value of its own. does it mean the clutch is gone. very recently selespeed pump only primes in the morning after opening the door while as it used to prime every time i open the door. Any help needed please. Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted October 27, 2015 It is a sign of a failing release bearing so a new clutch and inspection of the gear shafts is advisable. Quote Share this post Link to post Share on other sites
addicto111 0 Report post Posted October 27, 2015 Hi smaky thanks for your reply what about the pump is it normal for the pump to prime only once in morning at the opening of driver door and afterwards it doesn't prime on opening door And how much it will cost me for the new clutch and is it possible u can do a inspection of my car I can bring it down Quote Share this post Link to post Share on other sites
addicto111 0 Report post Posted October 28, 2015 Just want to update here I cleaned the pump relay next to battery box it resolved the pump problem so far Fingers crossed Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted October 31, 2015 So far... But just a little info for you, the pump only primes when it needs to, if the system is holding over 45 Bar when you open the drivers door or turn the key then the pump will not prime until the pressure drops below 44.5 Bar, this is controlled by the pressure sensor on the actuator. Quote Share this post Link to post Share on other sites
addicto111 0 Report post Posted November 1, 2015 Hi smaky is it possible u can have a look into my car I can bring it down if that z ok with u Quote Share this post Link to post Share on other sites
addicto111 0 Report post Posted November 28, 2015 very late reply it was actually my selespeed pump carbon brushes which i changed and it fixed the problem. Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted November 28, 2015 Hopefully the guide came in useful. Quote Share this post Link to post Share on other sites
addicto111 0 Report post Posted March 24, 2016 HI is there any chance somebody can check pinch bolt settings on the actuator of my selespeed Quote Share this post Link to post Share on other sites