davealfa11 0 Report post Posted November 17, 2011 when i connect to fiatscanecu my readings show low in 69 -73 range which as far as im concerned are tooooooo low ,swapping to another good one same readings i assume readings on idle to be more in region 250 + cam belt been checked as being spot on marks ..no air leaks from pipe work ie intercooler and assosiated pipe work read codes and ive got p0235 which translates to boost solenoid etc but its low air quality sympton from where i see it any thoughts Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted November 17, 2011 when i connect to fiatscanecu my readings show low in 69 -73 range which as far as im concerned are tooooooo low ,swapping to another good one same readings i assume readings on idle to be more in region 250 + cam belt been checked as being spot on marks ..no air leaks from pipe work ie intercooler and assosiated pipe work read codes and ive got p0235 which translates to boost solenoid etc but its low air quality sympton from where i see it any thoughts Guessing this is for the 2.4 over there>>>> Have you cleaned out the EGR and MAP sensor yet? I suspect this issue is being shown up by a clogged up MAP sensor on the back of the inlet manifold, dont poke anything into it, just use plusgas to break down any gunk in there. Quote Share this post Link to post Share on other sites
davealfa11 0 Report post Posted November 17, 2011 done all that and even blanked EGR off as well Quote Share this post Link to post Share on other sites
davealfa11 0 Report post Posted November 17, 2011 ill put you in full picture .....cam belt snapped last xmass and had 1 injestor overhauled and others cleaned so to speak .i wasnt able to do work as temps where down to -12....i thought poor economy was done to poor cam timing but had it checked by 2 independants ..black soot out of exhaust etc new MAP MAF recently i replaced turbocharger ,got missing power back and hardly any soot but i have a feeling its running too rich Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted November 18, 2011 Open up the EGR, Quote Share this post Link to post Share on other sites
davealfa11 0 Report post Posted November 19, 2011 open egr up again? can you elaborate please as in why? Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted November 25, 2011 To allow the engine to run properly. Quote Share this post Link to post Share on other sites
davealfa11 0 Report post Posted November 27, 2011 okay cheers smaky Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted November 27, 2011 okay cheers smaky np. Quote Share this post Link to post Share on other sites