Raxis

ill do both the sensors came in today so ill swap the engagement sensor now then the oil on the weekend since its a bit more messy, i was gonna pop the side off and check for swarf before the oil change wish me luck am feeling a bit stupid that i didnt buy 3 sensors, thems the breaks, ill get more if i need em

got it to 28.12, used some of my elec eng background to poke through the wiring saw some poor earthing and some questionable sockets which i got some cleaner and some connector grease into. sensors "seemed" fine including the clutch speed sensor (tested with a magnet ) tightened it all back up and this time ran EoL successfully. seemed nice and tight shifting sounded nice and consistent. went for a blast with the missus watched it with multiecuscan, then after it got a little warner, 15-20 mins of driving it started to skip 3rd into 4th or just outright fail to upshift and cook some clutch by dropping out of and back into 2nd. but while she cold at full throttle.... smooth as silk. came back home with the warmed up box ran EoL again still came up clean (cleared 1,2,3 switch errors from the seleECU) turned the car off went inside for a pee and when i came back out couldnt start the car, gearbox was stuck in 3rd....????? would swap to ALL other gears including 4/5 & reverse but would not go to N, as soon as i tried, jumped back to 3rd cooled down.... was fine again.... frustrating.... thinking one of the sensors has gone defunct? time to swap the engagement pot Smacky? i might also note the wiring on this particular selespeed unit is not the best a few of the connectors are brittle and have signs of fatigue, i want to replace that but noone in sydney can supply a selsepeed loom in good nick. Anyone know a trust worthy and honestly priced source i can score some selespeed bits?

Yhea thanks for that im not in melb unfortunately, im in sydney , am also somewhat paranoid about how much a mechanic is gonna change had bad experiences in the past hence i learned myself will pull the clutch rod back and see how we go!

Hi All, So heres the story, Just brought a 156 2.0 TS for my wife about a month ago, went over it all good no weird beeps and selespeed was smooth and pulled hard (love that nice little blip it does for downchanges Recently however its developed a couple of issues which ive worked on in 2 stages. Firstly, after warming up the clutch actuator appears to start doing full stroke when in neutral and when it does this the car bunnyhops, Im guessing this is either clutch pos sensor or EV0, tried rotating EV0 with another solenoid, but when i did this the clutch wouldnt move at all so i ended up swapping back just to get the car running gain. i notice if the car is moving on a freeway (cools down) the issue goes away untill it heats up clutch is at 29'ish mm at the moment, have done bleed and EOL, which made it a lot smoother and gave it better bite when cold but hasnt helped when hot. Seccondly, possibly in all my messing around i may have pissed something off in the gearbox or ive angered the little gremlins inside one of the other solenoids or (possibly the engagement sensor?), as the car now randomly decides it will skip 3rd gear into 4th and at its worst decides it wants to get stuck in 2nd or 4th, when i try to shift out of these gears the actuator appears to try but fails. pulling over and bouncing the actuators usualy sorts this out again and where good to go Im getting an ENG lever switch error popping up whenever this happens . Sometimes when starting the car wont go into neutral. it seems to try to move from 4th or 3rd to N but bounces back and forwards, if i bounce the actuators with multiecuscan to push the car into 2nd or reverse the car will then move to N then start. im starting to think maybe ive upset the orings on the engagement solenoid or possibly the pot Ive got 2 Pots comming in the post from the UK as i type this (should come next week) but am wondering where i can go in the meantime (would like to replace all the orings but cant find anywhere to get these in australia). Please help! Thanks in advance

Hey man, Im a noob on here too 156 2.0TS from sydney, no nasty supprises yet.... just a jumpy when hot selespeed

What's your AlfaDriver forum name: Raxis Whereabouts in the world are you?: Sydney Australi What are you driving these days?: Alfa 156 2.0TS Selespeed How did you find AlfaDriver?: Trawling the interwebs for selespeed diagrams Describe your introduction to the Alfa Romeo brand: Eyeballs pressed into the back of my head by a good friend "Introducing" his 147 GTA to me Outside of Alfa Romeo, what are your interests?: Motorcycles, Computers Building things, breaking things What do you do for a living?: Business information systems analyst (computer geek) Tell us an interesting/crazy/unusual fact about yourself: Uncanny ability to pick up technical knowledge in stupidly short periods of time What's your "special skill"?: read above If money was no object, what four vehicles would be in your dream garage?: - Dream daily driver: Alfa GT/159 3.2 JTS - Dream track car: Custom hand built composite tub MR - Dream all-rounder: VW R32 worked off its tits, just for kicks - Wildcard entry: Lamborghini Diablo What are you personally hoping to get out of AlfaDriver?: Knowledge about this bloody awesome little machine, the possiblity to contribute my hairpulling experiences to others in the process And finally, describe yourself in five words: persistent, geeky, fiddler, brutal, weird