Gt Selespeed Won't Start

[Gt Selespeed Won't Start]

I've had every fuse out and checked them; the fuses I could identify for the sele I've swapped with others of the same value. Really scratching my head here.

The next thing I was going to try was to trace continuity on the actuator wiring back to the ecu connector to see if it is the wiring harness causing a problem.

[Gt Selespeed Won't Start]

I'll try swapping it. Would that prevent the sele ecu from communicating on the CAN-bus?

[Gt Selespeed Won't Start]

Battery is nearly new and fully charged. I've cleaned the battery terminals and the earth strap where it bolts on to the gearbox. Everything else electrical seems to work except sele functions.

[Gt Selespeed Won't Start]

There's no display at all in the gear display section of the dash; it's blank. I think this may be because the sele ecu isn't sending any data. I don't hear a click from the passenger footwell when I turn the key and the starter doesn't spin.

 

There is a high pitched alarm when I open the driver's door, which I think is the Selespeed alarm

[Gt Selespeed Won't Start]

Yes, fluid level is up to the dipstick mark

[Gt Selespeed Won't Start]

Yes, pump runs.

[Gt Selespeed Won't Start]

Tried disconnecting battery and connecting red to black on car, presumably this discharges any residual charge in electronic units, but no joy. Egie ecu still doesn't see the sele ecu.

 

Any thoughts on the next thing to try?

[Gt Selespeed Won't Start]

Hi Smaky

 

Does this mean the actuator is toast, or the ecu?

 

Thanks

[Gt Selespeed Won't Start]

Hi

 

A Selespeed issue, but I can't find anything similar on any of the forums.

 

I have a 2005 GT Selespeed that won't start. This all started after driving to work through heavy rai and being unable to start the car 8 hours later when I finished work.

 

When I use MES to check for errors, the engine ecu reports U1701 which seems to mean no communication with Sele ecu over the CANbus.

MES won't connect to the Sele ecu; when I check the Body computer, it says the Sele ecu is defined but not found.

 

I've cleaned the gearbox earth, checked the fuses and relays, which all seem OK. I've checked the multi-pin plug, cleaned it and replaced it with no result.

 

I've charged the battery (less than 1 year old) and tried another fully charged battery without any success.

 

When I open the driver's door after connecting the battery, the pump primes and a high pitch tone sounds which I think is the alarm for a sele fault. Gear N shows on the dash until I turn the key to MAR at which point the gear indicator goes blank.

 

I'm all out of ideas; anyone any thoughts?

 

Thanks