Jump to content
Sign in to follow this  
el@d147

147 selespeed city mode and kangaroo jump problems

Recommended Posts

I'll start with the fact that i replaced the brakes booster unit (include the pump). 

 

Before that everything was just fine!

 

Now i have 2 problems:

 

1. In city mode the gears doesnt change, for example if i start from 1st gear the rpm goes up but the gear stay on 1st. Same problems with all gears if i go from any gear on manual to city, Gear stay on the last 1 before i changed to city mode from manual. 

 

2. In manual mode gears changes are ok except selespeed fail beeps and the kangaroo jumps problem. I have really bad kangaroo jumps from standing state on 1st gear (low rpm) until i rev up and change to 2nd gear. it feels like there is not enough fuel in the system. my guess its a sensor problem but its not a real direction to the solution. 

 

Btw, road clutch set to 28.1mm. 

 

I tried to do EOL calibration but i have problem almost 3 years with it. It failed and say: "Error due to absence of suitable conditions" 

 

Thanks for any help here

Edited by el@d147

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...