GTA 0 Report post Posted October 21, 2013 Hello! I am the lucky owner of a GTA Selespeed. Lovely car. While checking the car over in AlfaDiag, I see that the clutch distance is recorded at 30mm. Witha bit of googling, I can see that the normal Selespeed clutch is supposed to be at 28mm and the GTA Selespeed at 18mm. Is that correct ? If so how do I adjust it to the correct distance and setting ? Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted October 22, 2013 unfortunately there is no way to set the clutch length on the GTA/Abarth setup as fitted to the 156/Stilo, so wherever that has said it can be is mistaken, If the length is creeping up on this variant then a new clutch is required. Quote Share this post Link to post Share on other sites
GTA 0 Report post Posted October 22, 2013 A rather disappointing result. But thanks for the reply! Much appreciated. Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted October 22, 2013 You can though with the relevant software run the calibration routine which will give you a few more months. Quote Share this post Link to post Share on other sites
GTA 0 Report post Posted October 23, 2013 Did that, thanks Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted October 24, 2013 and? Quote Share this post Link to post Share on other sites
GTA 0 Report post Posted November 16, 2013 Well its working Still haven't changed the clutch though, if that is what you mean Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted November 19, 2013 If it works don't fix it, a lot cheaper that way. Quote Share this post Link to post Share on other sites
