alfadog

Thanks m8, Sorry to bother you over and over again but does this replacement require any bleeding and if so how does it get done. Thanks again for the help ! Mark

Hi, That helped me allot. Is there any advise you can give me to remove the pipes from the actuator: Would I need any special tools ? and also is there any part of the engine that I would have to remove in order to get the pipes wiggled out the tray section ? And one last thing did you have to bleed the system and if so how did you do it ? I very much appreciate your advice and thanks in advance for my next question. Mark

Hi there, I have had my Alfa for about 8 months now and its time for the brushes to be replaced,that being said I have gone ahead and removed the reservoir for the pump and the bracket holding the sele in place. My problem is that I am stuck due to a bolt that wont come lose and im scared of damaging other components in the pump. I have tried loosening the bolt with no effect so I wondered if it could be threaded the opposite way. Basically I'm looking for advice on how to remove this bolt ( Outlet pipe to selespeed pump with bolt holding it into place. http://www.google.co.uk/imgres?q=selesp ... =123&ty=73 If you have a look at the link it shows you number 4 (Inlet Pipe) and it is the pipe exactly next to it, the one going to the actual actuator. Hope I have explained my situation and that someone could give me some advise on the matter which would be greatly appreciated. Thanks