M.J.S 0 Report post Posted October 27, 2015 Hi All, On my 156 2.4JTDM 20v a vacuum hose is starting to split. I want to replace it, so does anyone know the correct internal diameter for the hose in the pic below? Its at the front of the engine bay. I measured it to be 4mm, but it seems the sizes for the car are 3.2 and 5mm. Any ideas? Thanks Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted October 31, 2015 3.2 Quote Share this post Link to post Share on other sites
M.J.S 0 Report post Posted October 31, 2015 As ever thanks Smaky! Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted October 31, 2015 It's available off the rack in Al Frauds Quote Share this post Link to post Share on other sites
M.J.S 0 Report post Posted October 31, 2015 :-) did it this afternoon. The pipe directly beneath it, I'd that the same size? It looks bigger Thanks Smaky! Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted November 3, 2015 It's the same, just you have to push it over the bulbous flange to get it on.....Hot water helps. Quote Share this post Link to post Share on other sites
M.J.S 0 Report post Posted November 3, 2015 Thanks again, I'll change that hose as well. 😊 Quote Share this post Link to post Share on other sites
