Gibot123 16 Report post Posted April 20, 2014 Hi Smaky as ive got the heads in bits on the dinning room table is there anything I can do with my Dremmel to improve the Inlet /outlet in the way of slight porting at all . If so what would you recommend. I've thought after looking at it that maybe marring up the inlet plate and the ports in the head as in matching the holes as theren is quite a difference between the two diameters the plate having a much smaller hole than the inlet on the head. Would really like your input Cheers. THe exhaust port on the head is smaller than the diameter of the inside of the gasket too. Quote Share this post Link to post Share on other sites
Smaky 73 Report post Posted April 20, 2014 If you start messing with things like that you'll just unbalance the flow from the cylinders, without the correct flow testing rig you'll never get it right. Quote Share this post Link to post Share on other sites
Gibot123 16 Report post Posted April 20, 2014 ok thought I would check good job i did thank you Quote Share this post Link to post Share on other sites